Measurement of target fragments produced by 160 MeV proton beam in aluminum and polyethylene with CR-39 plastic nuclear track detectors
Artikel i vetenskaplig tidskrift, 2014
Production of target fragments from reactions of 160 MeV proton beams in aluminum and polyethylene was measured with CR-39 plastic nuclear track detectors (PNTD). Due to the detection limit of PNTD, primary protons cannot be detected; only low-energy short-range target fragments are registered. As a feasibility study, a so called "two step etching method" was employed to get the linear energy transfer (LET) spectra, absorbed dose, and dose equivalent. This method is discussed in this paper, together with the measured results. (C) 2014 Elsevier Ltd. All rights reserved.
Aluminum
PARTICLES
CR-39
Polyethylene
LIGHT
Plastic nuclear track detectors
SHORT-RANGE
SENSITIVITY
Target fragments
High-energy protons
ION-BEAMS
ATOMIC-FORCE MICROSCOPE
LOW-EARTH-ORBIT
LINEAR-ENERGY-TRANSFER
Författare
I. Ambrozova
Nuclear Physics Institute of the Academy of Sciences of the Czech Republic v. v. i.
N. Yasuda
National Institute of Radiological Sciences Chiba
University of Fukui
S. Kodaira
National Institute of Radiological Sciences Chiba
Lembit Sihver
Chalmers, Teknisk fysik, Nukleär teknik
Radiation Measurements
1350-4487 (ISSN)
Vol. 64 29-34Ämneskategorier (SSIF 2011)
Atom- och molekylfysik och optik
DOI
10.1016/j.radmeas.2014.04.002